Rockwell Automation GV6000 Quick Reference Guide - Manual

Quick Reference Guide
Wiring /
Power Up /
Parameter Setting
Reliance Electric
GV6000 AC Drive
1/2 to 200 HP
Quick Reference Instructions:
A quick reference to some basic
configurations and drive features.
Volts/Hertz Regulation
Sensorless Vector Regulation
Flux Vector Regulation
D2-3544
OIM Keypad and Display
The supplied keypad and display allow for
setup, parameter adjustment, monitoring
and diagnostics.
Operator Interface Module (OIM)
NOTE: This material is not intended to provide
operational instructions. Appropriate Reliance
Electric Drives instruction manual information
and precautions should be studied prior to
installation, operation, or maintenance of
equipment.
Startup Menu
OIM Startup Menu
The Startup Menu parameters can be
accessed via the keypad tab menu. Once
into the selection list the following
parameters can be set to configure the
drive to the installed motor.
1. Quick Start
• Regulation Type
• Encoder PPR
• Speed Units
• Stop Type
• Motor NP FLA
• Maximum Speed
• Minimum Speed
• Accel Time
• Decel Time
• Speed Ref Select
• Current Limit
The default configuration is defined as:
Drive Voltage Rating = Motor Voltage
Start/Stop control = OIM
Speed Reference = OIM
Control Mode = Sensorless Vector
If the drive default configuration is to be
used for initial startup then the above
parameters are the only settings required.
If the user needs to customize the drive
configuration different than the default
setting, then the user should verify
parameter settings accessible throughout
start-up menu.
2. Input Voltages
• 200/240, 400/480, and 600 VAC,
based on model number
3. Motor Nameplate Data
• Motor NP Power
• Motor NP FLA
• Motor NP Volts
• Motor NP Hertz
• Motor NP RPM
Startup Menu
4. Motor Tests
• Direction Test
• Autotune
• Inertia Test
5. Reference Setup
• OIM Keypad, Analog Input, Network,
MOP, Frequency, Encoder, Presets
6. Configure I/O
• Digital Inputs/Outputs
• Analog Outputs
7. Step Saver, Applications
Control Mode
Motor Cntl Sel (53) performance can be
selected from:
• Sensorless Vector (default)
High performance control without
encoder feedback
• SV Economize
Sensorless vector with energy saving
• Custom V/Hz
Basic open loop control. Multi-motor
application
• Fan/Pump: V/Hz
Provides for a Fan load V/Hz curve
• FVC Vector
Highest performance mode of control
acheived with encoder feedback
SEL PARAM DIAG STARTUP
Startup
SEL PARAM DIAG STARTUP
Parameters
SEL PARAM DIAG STARTUP
Diagnostics
Display
SEL PARAM DIAG Display
Memory
SEL Diag Display Memory
Password
SEL Display Memory Psswrd
SEL
SEL
SEL
SEL
SEL
Quickstart
Motor Data
Motor Tests
Reference Setup
Configure I/O
Step Saver
Applications
Groups
Linear List
Changed Parameters
Alarms
Faults
Drive Status
Device Select
Device Name
Device Version
Device Items
Language
Disp Adjustments
Process Display
Reset Display
OIM CopyCat
Drive User Sets
Restore Defaults
Set Access Level
Set AccLvl Password
Set Wrt Prot Passwrd
Press to select a menu item.
SEL Press to move between two menu tabs.
ESC
PROG
Press to move 1 level back in the menu structure.
Press to move between menu items.
!
ATTENTION: Rotation of the
motor in an undesired direction
can occur during these
procedures. Failure to observe
this precaution could result in
damage to equipment or bodily
injury.