Rockwell Automation 2090-MPPC-X163 Size 36 Connector Kit for MP-B9xx Motor Power - Manual

Publication MP-IN011B-EN-P - April 2007
Installation Instructions
Size 36 Connector Kit for MPL-B9xx Motor Power
Catalog Number 2090-MPPC-X163
About This Publication
This publication provides wiring instructions for the Allen-Bradley Size 36 Connector Kit.
This connector kit provides an a 1½ NPT connection for conduit enclosing the power wire
run between the power connector on a MPL-B9xx motor and its input power source.
The MP-Series Installation Instructions, publication MP-IN002, details the motor interface.
Wire the Connector Kit
Refer to the illustration and the power connector pinout for your MPL-B9xx motor when
wiring this connector.
Tools you need to assemble the connector include a wire cutter, wire stripper, flatblade
screwdriver Ø 2.5 mm (0.10 in.) maximum, and solder iron.
Connector components are assembled in the order shown in the figure.
1. Thread each power wire through the connector backshell and lock ring.
ATTENTION
Do not use a petroleum based, or similar lubricant when inserting the pins into
the housing. This may effect the dielectric characteristics of the connector, and
the retention of the pins.
Alcohol or a lubricant that cleanly evaporates is recommended.
IMPORTANT
Always make effective electrical contact between the wire and pin connection.
360° shielding must be provided from the connector backshell to the drive.