Rockwell Automation DC2-71, 78, 91, and 98 Drive Fuse Kit Options For all DC2 Controllers except - Manual (Page 3)

3
ă3. Placethefaceplateon thesideof thecontroller
to gain access to the preĆdrilled holes located
abovethegrounding bar.
ă4. Install thefuseholder assembly on thechassis
using the two taptite screws provided in the
plastic bag with this kit.
ă5. Remove the existing wire labeled 151" from
terminal 51 of the Controller and terminal 4 of
theStart/Stop switch.
ă6. Using a flathead screwdriver, connect the wire
labeled 51" to terminal 51 of the Controller.
ă7. Connect thewirelabeled 151" to thebareterĆ
minal (terminal 4) of the Start/Stop switch.
ă8. Install thefuseinto theholder.
ă9. Placethefaceplateon theController and then
install the four (4) screws removed in step 2 of
this procedure.
REFERENCE DOCUMENTATION
D2Ć3231 Installing, Operating and Maintaining
DC2 VKS Drive