Hapter, Introduction, 1 related hardware and software – Rockwell Automation SA3100 Fiber-Optic Cabling-Distributed Pwr System User Manual
Page 9

Introduction
1-1
C
HAPTER
1
Introduction
This manual provides guidelines on the fiber-optic cabling used to connect AutoMax
™
Distributed Power System Universal Drive Controllers (UDC) and Power Module
Interfaces (PMI). The cable is immune to electromagnetic interference (EMI) and
eliminates ground loops.
The fiber-optic cable is a part of a point-to-point serial communication link between the
UDC module and the PMI. See figure 1.1.
The link allows the UDC module to transfer configuration, operating system, and
real-time control information to the PMI. The PMI in turn sends feedback and status
information to the UDC module. The UDC module is capable of supporting two links
operating independently of each other.
Data transferred over the fiber-optic link is Manchester-encoded and is transmitted at
a rate of 10M bits per second. Fiber-optic link specifications are provided in
Appendix A.
1.1
Related Hardware and Software
•
P/N 613613-xxS
Fiber-Optic Cable (Cable length (xx) is specified in meters.)
•
P/N 613613-1S
Fiber-Optic Test Cable (One meter test cable with
connectors attached.)
•
P/N 417135-2A
Fiber-Optic Coupler
Figure 1.1 – Fiber-Optic Serial Communication Link
AutoMax Processor
UDC Module
PMI
PMI
Fiber-Optic Cables
P/S