Rockwell Automation 8720MC Control Board Installation Instructions - Manual (Page 6)

6 8720MC Control Board
Publication 8720MC-IN003A-EN-P — January 2005
5. Remove all customer connections, ribbon cable, thermal switch,
SERCOS interface, and SCANport

connectosr from the control
board (refer to Figure 1 for locations).
6. Remove the six control board screws (hold the control board in
place until the last screw is removed).
Replacing the 8720MC Control Board
To replace the 8720MC control board:
1. Install the new control board and replace the six control board
screws.
2. Replace the customer connections, ribbon cable, thermal switch,
SERCOS interface, and SCANport

connectors (refer to Figure 1).
3. Replace the HIM adapter (if present) and the four screws removed
earlier.
4. With the mating connectors properly aligned, snap the HIM into
place.
5. Replace the drive cover and restore power to the drive.
6. Program the drive as described in the 8720MC High Performance
Drives Integration Manual (publication 8720MC-IN002x-EN-P).
ATTENTION
Only those familiar with SCANport devices and
associated machinery should plan or implement
the installation, startup, or subsequent
troubleshooting of this board. Failure to comply
may result in personal injury or damage to
equipment.