Warning notices – Rockwell Automation AutoMax R-Net Processor Module User Manual
Page 2
E Copyright Reliance Electric Industrial Company 1991.
MultibusR is a registered trademark of Intel Corporation.
AutoMaxt, RĆNett and ReSourcet are trademarks of Reliance Electric Company
orits subsidiaries.
Reliancer and AutoMater are registered trademarks of Reliance Electric Company
orits subsidiaries.
The information in this user's manual is subject to change without notice.
DANGER
ONLY QUALIFIED ELECTRICAL PERSONNEL FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THIS EQUIPMENT AND THE HAZARDS
INVOLVED SHOULD INSTALL, ADJUST, OPERATE, AND/OR SERVICE THIS
EQUIPMENT. READ AND UNDERSTAND THIS MANUAL IN ITS ENTIRETY
BEFORE PROCEEDING. FAILURE TO OBSERVE THIS PRECAUTION COULD
RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
DANGER
THE USER IS RESPONSIBLE FOR CONFORMING TO THE NATIONAL ELECTRIC
CODE AND ALL OTHER APPLICABLE CODES. WIRING, GROUNDING,
DISCONNECTS, AND OVERCURRENT PROTECTION ARE OF PARTICULAR
IMPORTANCE. FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN
SEVERE BODILY INJURY OR LOSS OF LIFE.
WARNING
RELIANCE STRONGLY RECOMMENDS THE USE OF AN EXTERNAL,
HARDWIRED EMERGENCY STOP CIRCUIT OUTSIDE THE PROGRAMMABLE
CONTROLLER CIRCUITRY. THE EMERGENCY STOP CIRCUIT MUST DISABLE
THE SYSTEM IN CASE OF IMPROPER OPERATION. FAILURE TO OBSERVE THIS
PRECAUTION COULD RESULT IN BODILY INJURY.
WARNING
THE RĆNET SYSTEM IS DESIGNED TO CONTINUE OPERATING IF ONE OR MORE
NODES ON THE NETWORK FAILS OR IS TAKEN OFF LINE. IF CERTAIN DATA
MUST BE TRANSFERRED RELIABLY TO ENSURE SAFE OPERATION, THEN THE
USER MUST ADD SOFTWARE HANDSHAKING IN THE APPLICATION PROGRAM
THAT WILL DETECT LOSS OF COMMUNICATION. FAILURE TO OBSERVE THIS
PRECAUTION COULD CAUSE BODILY INJURY.
CAUTION
THIS MODULE CONTAINS STATICĆSENSITIVE COMPONENTS. DO NOT TOUCH
THE CONNECTORS ON THE BACK OF THE MODULE. WHEN NOT IN USE, THE
MODULE SHOULD BE STORED IN AN ANTIĆSTATIC BAG. THE PLASTIC COVER
SHOULD NOT BE REMOVED. FAILURE TO OBSERVE THIS PRECAUTION COULD
RESULT IN DAMAGE TO OR DESTRUCTION OF THE EQUIPMENT.