Rockwell Automation 2711-PV1000 PanelView 1000 Terminals - Manual (Page 14)

14 PanelView 1000 Terminals
Publication 2711-IN036J-EN-P - November 2009
3. Apply 24V DC power to the terminal.
EtherNet/IP Protocol
The PanelView terminal is initially set to DHCP with BootP support (Dynamic Host
Configuration Protocol) enabled. If your network has a DHCP/BootP server, you can
connect the PanelView terminal to the EtherNet/IP network and the DHCP/BootP server
will automatically establish an IP address. If your network does not have a DHCP/BootP
server, you need to program an IP address. This is done by accessing Configuration Mode on
the PanelView terminal and selecting Communication Setup. For details, refer to the
PanelView Standard Operator Terminals Manual.
ATTENTION
Do not apply power to the terminal until all wiring connections have been made. Failure
to do so may result in electrical shock.
IMPORTANT
If a PanelView is connected to an EtherNet/IP network and has the same IP address as
another device on the network, both devices will drop off the network.
+
Earth Ground
DC Negative
DC Positive
Power Terminal
Block (fixed)