Rockwell Automation 2364E INST Air Flow Switch PCB and Pwr Sup Replacement - Manual (Page 4)

4 Air Flow Switch PCB and Power Supply Replacement
Publication 2300-5.12 - April 1998
Removing the Air Flow Switch
Power Supply Follow this procedure to remove an air flow switch power supply:
1. Remove all Lexan guards that shield the power supply.
2. Disconnect the input and output power wiring. (Refer to Figure
2.)
3. Snap the power supply out of the snap track.
Figure 2
Power Supply
Installing the Air Flow Switch
Power Supply Follow this procedure to install an air flow switch power supply:
1. Verify that the power supply has the proper rating according to
the information located on the system schematics.
2. Snap the power supply into the track.
3. Connect and verify the input and output power wiring.
4. Replace any Lexan guards that you removed.
5. Dispose of the removed part according to your company’s proce-
dures and local ordinances.