Rockwell Automation 2707-M232P3xX, -M485P3X DTAM Micro Operator Interface Installation Instructions - Manual (Page 11)

DTAM Micro Operator Interface 11
To download an application to the DTAM Plus, you must:
•
connect a power supply (see Connecting DC Power on page 8)
•
connect the (Catalog No. 2707-NC2) upload/download cable if
you have the RS-232 version
•
connect the (Catalog No. 2707-NC5) upload/download cable if
you have the RS-485 version. This cable converts the computer’s
RS-232 output to RS-422 which is compatible with the DTAM
Micro RS-485 port.
To Computer
RS-232 Port
RS-485 Version (Catalog No. 2707-M485P3)
Use Upload/Download Cable (Catalog No. 2707-NC5)
RS-232 Version (Catalog No. 2707-M232P3)
Use Upload/Download Cable (Catalog No. 2707-NC2)
DTAM Micro
To connect the DTAM Micro to an RS-232 device:
1. Make sure that the DTAM Micro is not connected to a voltage
source.
2. Use the proper cabling to connect the DTAM Micro
communications port to the port of the controller (PLC-5 channel
0 or SLC 5/03, 5/04 or 5/05 RS-232 port).
•
Use cable, Catalog No 2707-NC3 for PLC-5 channel 0
connection.
•
Use cable, Catalog No. 1747-CP3 for SLC 5/03, 5/04 or 5/05
port connection. This cable requires a 9-pin female to male
gender adapter.
If you need to make your own cable, refer to the cable diagrams
in Appendix B of the DTAM Micro User Manual (2707-803).
The maximum recommended cable length is 50 feet
(15.2 meters).
3. Make sure that the communication parameters of the DTAM
Micro terminal match the host device.
4. Apply power and verify that communications are established.
Upload / Download
Connections
Connecting to Devices