Rockwell Automation 2711-NC2 PanelView Remote Keyswitch/RS-232 Port Assembly - Manual

Installation Data
ID
1
Remote Keyswitch and RS-232 Port Assembly
(Cat. No. 2711-NC2)
(For PanelView 1200, 1200e and 1400e Terminals;
Cat. Nos. 2711-KA1, 2711-KC1, 2711-TA1, 2711-TC1, 2711-TA4,
2711-TC4, 2711E-T12C6, 2711E-K12C6, 2711E-T12C4,
2711E-K12C6L2, 2711E-T14C6, 2711E-K14C6)
The Remote Keyswitch and RS-232 Port Assembly consists of a Mode
Select Keyswitch and an RS-232 port installed in a housing. This assembly
can be mounted in a location that provides easier access than the keyswitch
and port on the rear of the PanelView terminal.
The assembly is attached to a 10 foot (3 m) cable that connects to the
RS-232 serial interface port on the rear of the PanelView terminal. It must
be mounted with the attached gasket, washers, and screw-on cap. The cap
must be fastened to one of the mounting screws with the chain provided.
When not in use, the cap protects the assembly to maintain a NEMA 4X
rating (indoor use only).
Figure 1
Remote Keyswitch and RS-232 Port, Front View
20158a
RS-232
SERIAL INTERFACE
CONFIGURE
RUN
With Cap On
Screw and Washer x4
Chain is fixed to lower left corner.
Note orientation of washer.
Chain
Protective Cap
With Cap Off
Description