Rockwell Automation 2711C-NVxx Antiglare Overlay - Manual (Page 4)

Publication 2711-IN054A-EN-P - March 2007 PN 40061-337-01(8)
Supersedes Publication 2711-IN004G-MU-P - December 2002 Copyright © 2007 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
Hold the peeled-back portion of the protective layer out of the way as you
perform the next step.
2. Center the antiglare overlay on the terminal and carefully position the
exposed adhesive surface on the terminal.
While the protective layer is still covering the rest of the overlay, verify that
the overlay is properly centered.
3. Slowly peel off the rest of the protective layer, while using a soft cloth to
press the antiglare overlay on the screen.
Make sure that the overlay lies flat with no bubbles or warps.
4. With a soft cloth or the flat surface of a fingernail, press around the edges of
the overlay to completely seal it, and remove any air bubbles trapped in the
adhesive.
Clean the Overlay
Clean the overlay by using a clean, lint-free cloth and Windex or a mild glass
cleaner that leaves no streaks. Avoid cleaners containing abrasives. Eyeglass cleaner
is recommended when possible.
Remove the Overlay
If it is necessary to remove the overlay, lift up a corner and slowly pull the overlay
off. Use isopropyl alcohol to remove any residual adhesive.
Removing the overlay reduces the effectiveness of the adhesive. We recommend
that you do not reuse the overlay.
Overlay
Bezel
Protective Layer
(Covers Adhesive)