Rockwell Automation 2706 Dataliner 10 Message Display - Manual (Page 4)

Dataliner DL10 Message Display 4
Allow enough space within the enclosure for adequate ventilation. Consider heat
produced by other devices in the enclosure. The ambient temperature around the
display must be between 0
_ and 50_C (32_ and 122_F).
Make provisions for accessing the back panel of the display for wiring,
maintenance, and troubleshooting.
Required Tools
Other than the tools required to make the panel cutout, the tools required for
installation are:
•
3/8 inch deep well socket wrench
•
small slotted screwdriver
•
torque wrench (in. / lbs).
Installing Display in Panel
To install the Dataliner display:
!
ATTENTION: Disconnect all electrical power from the panel before
making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any components
that may already be installed in panel.
Failure to follow this warning may result in personal injury or damage
to the panel components.