Rockwell Automation 2361 Bridge Fan and Capacitor Replacement - Manual (Page 5)

Publication 2361-5.16 April 1999
Bridge Fan and Capacitor Replacement (for 1250 and 1650A 1395 DC Drives) 5
Unit With Two Capacitors
A single capacitor will be installed to replace the two existing capacitors.
1. Remove the mounting nuts for each capacitor. Remove the capacitors.
2. Drill two 1/8” holes for the new mounting bracket as shown in Figure 3
(you may use the bracket as a guide).
3. Vacuum any metal shavings from inside or outside of the unit. Do not
use compressed air.
4. Secure the new capacitor to the sheet metal with the bracket and its two
mounting screws from this kit.
5. Connect the leads of the new wire harness to the capacitor as shown in
Figure 2.
6. Connect the coupling.
Figure 3
Unit With Two Capacitors
2.5”
(64m
m)
1/8” (3mm) diameter holes
Removing the capacitors Preparing mounting holes for the new bracket
3.0”
(76mm)
4.0”
(101
mm)
Mounting nuts
Left wall of fan enclosure