Rockwell Automation 2364 NRU/RGU DC Bus Energized Pilot Light and Legend Plate Replacement - Manual (Page 3)

NRU/RGU DC Bus Energized Pilot Light and Legend Plate Replacement 3
Step 3: Installing the New
Pilot Light and Legend Plate 1. Place the proper combination of gaskets, determined from Table 1 below,
onto the bushing and insert the bushing through the rear of the panel. The
surface marked “TOP” should be in line with the anti-turn notch in the
panel.
Figure 1 Bulletin 800MR Pilot Light Assembly
2. Install the legend plate on the bushing in line with the anti-turn notch in
the panel.
3. Thread the “thin” mounting ring onto the bushing and tighten to
compress the gaskets and to secure the unit on the panel.
4. Push the lens assembly into the bushing.
5. Thread the “tall” mounting ring onto the bushing and tighten against the
thin mounting ring.
Table 1: Number of Gaskets Required
Panel Thickness
.067 in. (1.7 mm) Gasket (Black) + .034 in. (0.9 mm) Gasket (Red)
1/16 in. (1.6 mm) 3 + 2
3/32 in. (2.4 mm) 3 + 1
1/8 in. (3.2 mm) 3 + 0
5/32 in. (4.0 mm) 2 + 1
3/16 in. (4.8 mm) 2 + 0
7/32 in. (5.6 mm) 1 + 1
1/4 in. (6.4 mm) 1 + 0