Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad Installation Instructions User Manual
Page 15
Industrial Integrated Display Computers with Keypad 15
Rockwell Automation Publication 6180P-IN001C-EN-P - July 2013
b. Remove the old battery from its socket.
6. Insert the new battery with the positive polarity (+ side) facing up, and make sure that it
is seated completely.
7. Observe the post-configuration procedure.
a. Make sure that all components are installed according to the described step-by-step
instructions.
b. Make sure that no loose tools or parts are left inside the computer.
c. Reinstall any expansion boards, peripherals, board covers, and system cables that have
previously been removed.
d. Reinstall the back cover.
e. Connect all external cables and the AC power cord to the computer.
f. Press the power switch to turn on the computer.
8. Reconfigure the BIOS settings.
IMPORTANT
Replacing the battery results in all BIOS settings returning to their default settings.
BIOS settings other than default must be reconfigured after replacing the battery.
This product contains a hermetically-sealed lithium battery that may need to be replaced
during the life of the product.
At the end of its life, the battery contained in this product should be collected separately from
any unsorted municipal waste.