Rockwell Automation 2711P-RNxxx Communication Modules Installation Instructions - Manual

Installation Instructions
Communication Modules
Catalog Numbers 2711P-RN6, 2711P-RN6K, 2711P-RN15S, 2711P-RN15SK, 2711P-RN20
About This Publication
This document provides instructions on how to install or replace a communication module on a
PanelView Plus™ 6 or PanelView Plus 700, 1000, 1250, or 1500 terminal.
The communication module installs over the logic module. The installation is the same for all
communication modules regardless of communication type.
Additional Resources
You can view or download publications at http://www.rockwellautomation.com/literature/ . To
order paper copies of technical documentation, contact your local Allen-Bradley distributor or
Rockwell Automation sales representative.
Topic Page
Important User Information 2
Install a Communication Module 3
Replace a Communication Module 4
Cat. No. (1)
(1) These installation instructions also apply to other cat. no. 2711P-RN xx communication modules.
Communication
Conformal
Coated
Marine
Certified
Ethernet DH+™ DH-485 Remote I/O (3)
(3) Only supported on PanelView Plus 700 to 1500 terminals running FactoryTalk® View Machine Edition software, version 5.1 or earlier.
ControlNet
2711P-RN6 • • •
2711P-RN6K • • • •
2711P-RN15S • •
2711P-RN15SK • •
2711P-RN20 (2)
(2) Only supported on PanelView Plus 6 - 700 to 1500 terminals running firmware revision 6.10.17 or later.
•
IMPORTANT The logic module must be attached to a PanelView Plus display module before you attach the
communication module.