beautypg.com

Rockwell Automation 2193FZ Feeder Circuit Breaker Units Secure Support Pan and ChangeDoor Latch User Manual

Installation instructions, About this publication, Required tools

background image

Installation Instructions

Feeder Circuit Breaker Units Secure Support Pan and Change

Door Latch

Catalog Numbers 2193FZ

About This Publication

This document provides instructions on how to replace the

¼-turn door latch found in the center right-hand side of the unit door, with a new

swing-out latch bracket. These instructions apply only to plug-in Feeder units,

0.5 space factor, that incorporate a 225 A/250 A frame circuit breaker (regardless

of trip setting). This document also covers the addition of fasteners to the

support pans for these plug-in units.

Refer to

Figure 1

for a description of the parts of a CENTERLINE

2100 motor

control center section.

This document is intended for 0.5 space factor Bulletin 2193F plug-in units with

a 225/250 A frame circuit breaker.

Required Tools

You need the following tools:

Small flat-bladed screwdriver
5/16 in. and a 3/8 in. socket wrench
Optional, battery operated screwdriver

Topic

Page

About This Publication

1

Required Tools

1

Important User Information

2

Before You Begin

4

Secure the Support Pan and Change the Door Latch

4

Remove the Feeder Unit from the Section

4

Remove the Unit Below the Feeder Unit

6

Secure the Support Pans

6

Install Swing-out Latch Bracket

8

Install Units

8

Install New Door Latch Screw and Label

10

Additional Resources

12