Rockwell Automation 1738-XXXX ArmorPoint 24V dc Output Modules, Series A - Manual (Page 6)

Publication 1738-IN001C-EN-E - June 2005
6 ArmorPoint 24V dc Output Modules, Series A
Install the ArmorPoint
Digital Output Module To install the ArmorPoint digital output module, proceed as follows.
1. Using a bladed screwdriver, rotate the keyswitch on the
mounting base clockwise until the number 1 aligns with the
notch in the base.
2. Position the module vertically above the mounting base.
The module bridges two bases.
3. Push the module down until it engages the latching mechanism.
You hear a clicking sound when the module is properly
engaged.
The locking mechanism locks the module to the base.
Remove the Module From the Mounting Base
To remove the module from the mounting base:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the
latch.
The module lifts up off the base.
3. Pull the module off of the base.
MOD
NET
0
1
2
3
4
5
6
7
1738-OB8EM12/A
24V dc Out
0
1
2
3
4
5
6
7
Module bridges two bases.
43771