Rockwell Automation 1792-IB8/B INSTL.INST ARMOR BLOCK 8 INPUT - Manual

ArmorBlock is a trademark of Allen-Bradley Co. Inc. Publication 1792-5.2 – October 1996
ArmorBlock 8 Input Module
Cat. No. 1792-IB8 Series B
To: See page:
Install the ArmorBlock  Module 3
Connect the Wiring to the ArmorBlock Module 8
Communicate with Your ArmorBlock Module 10
Configure Your ArmorBlock Module Offline Using the DeviceNet
Manager Configuration Tool 11
Configure Your ArmorBlock Module Online Using the DeviceNet
Manager Configuration Tool 17
Reset Faults 25
Configure Your ArmorBlock Module with EDS Files 28
For this reference information See page:
Default Configuration 14
Status indicators 34
Troubleshooting 34
Specifications 35
This 1792 ArmorBlock

I/O block module ( Cat. No. 1792-IB8 )
contains I/O circuits, a built-in power supply, and a built-in DeviceNet
I/O adapter. Because of its sealed housing, this 1792 I/O block requires
no enclosure. It is compatible with PLC or SLC programmable
controllers using DeviceNet scanners. The I/O values are accessible
from the PLC or SLC programmable controller data table.
This ArmorBlock module has no switches to set. You set module
parameters using the DeviceNet Manager Software (cat. no.
1787-MGR) or similar configuration tool.
Installation Instructions