Rockwell Automation 1769-SM1 Compact I/O-to-DPI/SCANport Network Communication Module User Manual
Rockwell Automation Equipment
Installation Instructions
1769-SM1 Compact I/O-to-DPI/SCANport
Network Communication Module
This document explains how to install a 1769-SM1 Compact I/O-to-DPI/SCANport
Network Communication Module into the controller.
Related Documentation
Documentation can be obtained online at
.
To order paper copies of technical documentation, contact your local Rockwell
Automation distributor or sales representative.
For information such as firmware updates and answers to drive-related questions, go
to the Drives Service & Support web site at
and click
on the “Downloads” or “Knowledgebase” link.
!
ATTENTION: Risk of equipment damage exists. Remove power before
installing or removing the 1769-SM1 module. When you install or remove
the module with power applied, an electrical arc may occur. An electrical
arc can cause personal injury or equipment damage by:
• Sending an erroneous signal to your system’s field devices, causing
unintended machine motion.
• Causing an explosion in a hazardous environment.
Electrical arcing causes excessive wear to contacts on both the module
and its mating connector. Worn contacts may create electrical resistance.
!
ATTENTION: Risk of equipment damage exists. The 1769-SM1
module contains ESD (Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the module. If you are unfamiliar
with static control procedures, refer to Guarding Against Electrostatic
Damage, Publication 8000-4.5.2.
Document
Description
1769-SM1 Compact I/O-to-DPI/SCANport
Network Communication Module User
Manual, publication 1769-UM010
Provides complete installation, wiring, setup, and
communication information for the 1769-SM1 Network
Communication Module.
Guarding Against Electrostatic Damage,
publication 8000-4.5.2
Provides static control procedures for protecting
electrostatic discharge sensitive parts.
Wiring and Grounding Guidelines for PWM
AC Drives, publication DRIVES-IN001
Guidelines for proper wiring, grounding, and shielding, and
standard practices for noise protection.
Step 1
Remove power from the controller.