Rockwell Automation 1756-DH485 ControlLogix DH-485 Communication Module User Manual - Manual (Page 47)

1 Publication 1756-UM532A-EN-P - May 2006
Chapter
4
Use RSLinx Software to Create a Routing
Table
Introduction This chapter describes how to configure your 1756-DH485 module in
DH-485 applications. For more information on the configuration software,
refer to the online help in each.
Choose the Correct
Software The programming software you need is dependent on what products you are
using with the 1756-DH485 module. The table below explains what software is
needed for your application.
For See
Choose the Correct Software 4-1
Use RSLinx Software to Create a Routing
Table 4-2
Create the Routing Table 4-3
Software Needed for 1756-DH485 Applications
If you are using this product with the
1756-DH485 module to read/write data
in a DH-485 application You must use this software
SLC Controllers RSLinx, version 2.43 or later
RSLogix 500, version 6.3 or later
ControlLogix Controllers RSLinx, version 2.43 or later
RSLogix 5000