Rockwell Automation 1734-ACNR Point I/O ControlNet Adapter Installation Instructions - Manual (Page 7)

7
Publication 1734-IN582B-EN-P - February 2005
Install the ControlNet Adapter
To install the adapter on the DIN rail prior to installing other base
units, proceed as follows.
1. Position the adapter vertically above the DIN rail.
2. Press down firmly to install the adapter on the DIN rail. The
locking mechanism will lock the adapter to the DIN rail.
3. Set the node address on the node address thumbwheel.
4. Remove the safety end cap by sliding it up. This exposes the
backplane and power interconnections.
ATTENTION
You must use Series C Point I/O modules with the
1734-ACNR. Series A and B Point I/O modules will
not work with the 1734-ACNR.
WARNING
If you connect or disconnect the ControlNet
cable with power applied to this module or any
device on the network, an electrical arc can
occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
ATTENTION
Do not discard the end cap. Use this end cap to
cover the exposed interconnections on the last
mounting base on the DIN rail. Failure to do so
could result in equipment damage or injury from
electric shock.