Rockwell Automation 1771-P4S_P6S_P4S1_P6S1 Power Supply Modules Installation Instructions - Manual

1 Publication 1771-IN079A-EN-P - June 2002
Installation Instructions
Allen-Bradley Power Supply Modules
(Cat. No. 1771-P4S, -P6S, -P4S1, -P6S1)
To the Installer This document provides you with the following information:
Important User Information Because of the variety of uses for the products described in this publication,
those responsible for the application and use of these products must satisfy
themselves that all necessary steps have been taken to assure that each
application and use meets all performance and safety requirements,
including any applicable laws, regulations, codes and standards. In no
event will Rockwell Automation be responsible or liable for indirect or
consequential damage resulting from the use or application of these
products.
Any illustrations, charts, sample programs, and layout examples shown in
this publication are intended solely for purposes of example. Since there are
many variables and requirements associated with any particular installation,
Rockwell Automation does not assume responsibility or liability (to include
intellectual property liability) for actual use based upon the examples shown
in this publication.
Allen-Bradley publication SGI-1.1, Safety Guidelines for the Application,
Installation and Maintenance of Solid-State Control (available from your
local Rockwell Automation office), describes some important differences
between solid-state equipment and electromechanical devices that should be
taken into consideration when applying products such as those described in
this publication.
For this information: See page:
Important User Information 1
What this Power Supply Package Contains 4
Install the Module 4
Set the Jumpers 4
Place the Power Supply in a Chassis 5
Connect a Paralleling Cable 6
Connect Input Power 7
Interpreting the Indicators 9
Troubleshooting a Single Power Supply 9
Troubleshooting Parallel Power Supplies 10
Specifications 12