Rockwell Automation 1771-OWN Selectable Contact Installation Instructions - Manual

Publication 1771-IN037B-EN-P - July 2002
Selectable
Contact Output Module
(Catalog Number 1771–OWN)
Use this document as a guide when installing the catalog number
1771-OWN series B contact output module.
To See page
Important User Information 1
Preinstallation Considerations 4
Power Supply Requirements 4
Key the Backplane Connector 5
Set the Relay Output Jumpers 5
Install the Module andFieldWiring Arm 7
Connect Wiring to the FieldWiring Arm 8
For this reference information See page
Interpreting the Status Indicators 11
Hazardous Location Approval 12
Specifications 13
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Rockwell Automation be
responsible or liable for indirect or consequential damage resulting
from the use or application of these products.
Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Rockwell Automation does not
assume responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.
Allen–Bradley publication SGI–1.1, Safety Guidelines for
Application, Installation, and Maintenance of Solid–State Control
(available from your local Rockwell Automation office), describes
some important differences between solid–state equipment and
electromechanical devices that should be taken into consideration
when applying products such as those described in this publication.
Installation Instructions
Contents
Important User
Information