Rockwell Automation 1771-P7 AC (120/220V) 16A Power Supply Installation Instructions - Manual

Publication 1771ĆIN056B EN-P - December 2001
AC (120/220V) 16A
Power Supply
(Cat. No. 1771-P7 Series D)
This document provides you with the following information:
For this information See page
important user information 1
preparing to install the power supply 3
installing the power supply 5
connecting ac power to the power supply 11
troubleshooting 12
power ratings 12
mounting dimensions 12
UL/CSA hazardous location approval 14
specifications 15
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of this
equipment must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards.
In no event will the Allen-Bradley Company be responsible or liable
for indirect or consequential damages resulting from the use or
application of this equipment.
The examples and diagrams in this manual are included solely for
illustrative purposes. Because of the many variables and
requirements associated with any particular installation, the
Allen-Bradley Company cannot assume responsibility or liability for
actual use based on the examples and diagrams.
Allen-Bradley publication SGI-1.1, “Safety Guidelines for the
Application, Installation and Maintenance of Solid State Controls”
describes some important differences between solid state equipment
and hard–wired electromechanical devices that should be taken into
consideration when applying products such as those described in this
publication.
Reproduction of the contents of this manual, in whole or in part,
without written permission of the Allen-Bradley Company is
prohibited.
Important User Information
Installation Instructions
To the Installer