Barco R9010010 - Manual (Page 118)

9. Service Mode
9.15.6 Voltages
How to select the overview?
1. Push the cursor key ↑ or ↓ to highlight Voltages. (menu 9-48)
2. Press ENTER to select.
The voltage overview window will be displayed. (menu 9-49)
DIAGNOSIS
I2C
FORMATTER
SMPS
LPS1
LPS2
LPS3
VOLTAGES
FANSPEED
Select with ↑ or ↓
then
to return
Menu 9-48
VOLTAGES
FAN1 VOLTAGE 14V OK
FAN2 VOLTAGE 14V OK
FAN3 VOLTAGE 17V OK
15 VOLT 14V OK
30 VOLT 29V OK
12 VOLT 12V OK
5 VOLT 5.0V OK
3.3 VOLT 3.1V OK
to return
Menu 9-49
9.16 Factory defaults
What is possible ?
The projector will set all settings to the factory defaults which are by default stored in the projector. All custom settings will be deleted
and the custom files will be removed.
How to return to the factory defaults ?
1. Push the cursor key ↑ or ↓ to highlight Factory defaults. (menu 9-50)
2. Press ENTER to select.
The Factory defaults confirmation and warning menu will be displayed. (menu 9-51)
3. Are you sure to restore the factory defaults ?
If yes, press the cursor key ↑ or ↓ to highlight Continue.
A message will be displayed. (menu 9-52)
If no, press the cursor key ↑ or ↓ to highlight Return.
SERVICE
BARCO LOGO
ADD INS
PRESET INPUT BALANCE
ADVANCED PROCESSING
DIAGNOSIS
FACTORY DEFAULTS
MORE...
Select with ↑ or ↓
then
to return
Menu 9-50
FACTORY DEFAULTS
ARE YOU SURE ?
THIS WILL OVERWRITE
ALL CUSTOM SETTINGS
AND DELETE ALL
CUSTOM FILES.
RETURN
CONTINUE
Select with ↑ or ↓
then
to return
Menu 9-51
Factory defaults
Please wait
Remaining time : x sec
Menu 9-52
Restoring the factory defaults can take a while. When finished, the projector will automatically reboot and
those factory settings will be loaded.
114 R5976563 BARCOR10 SLM 20/10/2004