Barco R9010010 - Manual (Page 105)

9. Service Mode
9.5 Changing Language
Start up
1. Push the cursor key ↑ or ↓ to highlight Change Language. (menu 9-11)
2. Press ENTER to display the Change Language menu. (menu 9-12)
3. Push the cursor key ↑ or ↓ to highlight the desired language.
4. Press ENTER to change the language.
Available languages: English
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then
to return
Menu 9-11
CHANGE LANGUAGE
ENGLISH
Select with ↑ or ↓
then
to return
Menu 9-12
9.6 Change Projector Address
How to change the projector address?
1. Push the cursor key ↑ or ↓ to highlight Change Proj Address. (menu 9-13)
2. Press ENTER.
The Change Projector Address menu will be displayed and the actual address will be filled in. (menu 9-14)
3. Push the cursor key ↑ or ↓ to highlight Projector address.
4. Press ENTER to activate.
The first digit will be highlighted.
5. Reprogram the address with ↑,↓,←,→ keys
Use the ↑ or ↓ key to select a new value, use the ← or → key to select a new digit.
Or,
use the numeric keys on the RCU to enter the new address.
The address must be between 0 and 9 when controlling the projector with the RCU or
between 0 and 255 when controlling the projector via RS232.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then
to return
Menu 9-13
CHANGE PROJ. ADDRESS
PROJECTOR ADDRESS 1
COMMON ADDRESS (RC5) 0
COMMON ADDRESS (PPM) 0
Select with ↑ or ↓
then
Reprogram with ↑ , ↓ , ← , →
or numeric keys
to confirm
to return.
Menu 9-14
How to change the common address
1. Push the cursor key ↑ or ↓ to highlight Change Proj Address. (menu 9-15)
2. Press ENTER.
The Change Projector Address menu will be displayed and the actual address will be filled in. (menu 9-16)
3. Push the cursor key ↑ or ↓ to highlight Common address.
R5976563 BARCOR10 SLM 20/10/2004 101