beautypg.com

Rockwell Automation 1771-OBDS DC(10-40V)Current Limiting Input Module Installation Instructions User Manual

Dc (10ć40v) current limiting output module, Installation instructions, Cat. no. 1771ćobds

background image

Publication 1771ĆIN033B-EN-P - July 2002

DC (10Ć40V) Current Limiting

Output Module

Cat. No. 1771ĆOBDS

Use this document as a guide when installing the catalog number
1771-OBDS output module.

For information on:

See page

Important User Information

1

Preinstallation Considerations

4

Calculate Power Requirements

4

Set the Fault Mode Selection Jumper

4

Key the Backplane Connector

5

Install the Module and Field Wiring Arm

6

Connect Wiring to the Output Module

7

Short Circuit Protection

10

Replacing the Fuse

11

For this reference information

See page

Intepreting the Status Indicators

10

Hazardous Location Approval

12

Specifications

13

Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Rockwell Automation be
responsible or liable for indirect or consequential damage resulting
from the use or application of these products.

Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Rockwell Automation does not
assume responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.

Important User Information

Installation Instructions

To The Installer