Rockwell Automation 1792D-8BVT8CD ArmorBlock MaXum 8 Input/8 Output Module with Complete Diagnostics - Manual (Page 7)

ArmorBlock MaXum 8 Input / 8 Output Module Series B 7
Publication 1792D-IN020B-EN-P - September 2000
I/O connectors for this module are shown below.
Output Power and DeviceNet Cables
Output power and DeviceNet cables are described in the installation
publications for the cable base assembly of your choice. Refer to the following
publications:
• 1792D-IN009B-EN-P ArmorBlock MaXum Cable Base Installation
Guide
• DN-6.7.2 DeviceNet Cable Planning and Installation Manual
ATTENTION
!
• Make sure all connectors and caps are securely
tightened to properly seal the connections against
leaks and maintain IP67 requirements.
• For maximum noise immunity, input and output
cable return wires must be properly terminated.
When inputs and outputs are connected in
loopback, return wires should be connected
together.
• I/O cable length should be less than 30 meters.
I-4
I-5
I-6
I-7
O-4
O-5
I-2
I-3
O-2
O-3
O-6
O-7
Logic Status Net/Mod Status
I-0
I-1
O-0
O-1
Auxilary Power
41517
Input 0
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Output 0
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
Output 7
Connector A
Connector B
Connector C
Connector D
Connector E
Connector F
Connector G
Connector H