Rockwell Automation 1771-QRD PULS FLOWMTR - Manual (Page 32)

Module Programming
Chapter 4
4–14
4. Enter the Block Transfer Rung found in Figure 4.16 into the
PLC–3/10 processor.
Figure 4.16
Block Transfer Rung for a PLC-3/10 with Remote I/O
5. Place the PLC–3/10 Processor in RUN mode.
Use the DATA MONITOR to examine data table address #N40:0. This is
where the QRD has stored the rates from the four channels.
Only the channels which are actually driven will be active.