Rockwell Automation 1756-EN2T ControlLogix EtherNet/IP Module Installation Instructions User Manual
Controllogix ethernet/ip module, Installation instructions, About this publication
Installation Instructions
ControlLogix EtherNet/IP Module
Catalog Number 1756-EN2T
About This Publication
Use this publication as a guide to install the module. This publication describes
hardware installation only. For configuration information, refer to the
EtherNet/IP Modules in Logix5000 Control Systems User Manual, publication
iew or download this publication at
Topic
Page
Determine Module Slot Location
Connect the Module to the EtherNet/IP Network
Program the Module via the USB Port
Check Power Supply and Module Status
Install or Remove the Module Under Power
Table of contents
Document Outline
- 1756-IN603C-EN-P, ControlLogix EtherNet/IP Module Installation Instructions
- About This Publication
- Important User Information
- North American Hazardous Location Approval
- Environment and Enclosure
- Prevent Electrostatic Discharge
- About the Module
- Before You Begin
- Determine Module Slot Location
- Set the Network Address
- Install the Module
- Connect the Module to the EtherNet/IP Network
- Program the Module via the USB Port
- Configure the Module
- Apply Chassis Power
- Check Power Supply and Module Status
- Install or Remove the Module Under Power
- Interpret the Status Indicators
- Specifications
- Additional Resources
- Back Cover