Rockwell Automation 1769-SDN Compact I/O DeviceNet Scanner Module Installation Instructions - Manual (Page 16)

16 Compact I/O DeviceNet Scanner Module
Publication 1769-IN060C-EN-P - May 2002
Configuring the 1769-SDN on DeviceNet
The 1769-SDN must be configured using a DeviceNet configuration tool. The
recommended configuration software is RSNetWorx for DeviceNet (version 3.00 or
higher).
This configuration tool allows you to identify all of the devices (I/O modules,
power supplies, expansion cables, end caps) and their locations in your system.
For more information, refer to the Compact I/O DeviceNet Scanner Module User
Manual, publication 1769-UM009A-EN-P.
TIP
If your RSNetWorx configuration software does not include the
required EDS (Electronic Data Sheet) file, it is available via
http://www.ab.com/networks/eds.
TIP
The controller must be in the Run mode, or the scanner in the
Idle mode (bit 0 of the Module Command Array = 0), for the
scanner to accept the configuration information.