Rockwell Automation 1494V-DS30 - DSX200 Disconnect Switch and Accessories - Manual (Page 4)

(4)
Connecting Rod Adjustment Procedure
"ON" Position
 Move disconnect handle to the "ON" position.
 If switch does not fully close, return handle to "OFF" position.
 Remove link spring hitch pin and disengage the connectiong rod from the primary link.
 Turn connecting rod counter-clockwise (1 or more) full turns.
 Re-engage connecting rod in primary link of handle, insert hitch pin and re-test
 Repeat  -  as necessary.
 Re-install link spring
"OFF" Position
 Move disconnect handle to the "OFF" position.
 If switch does not fully open, return handle to "ON" position.
 Remove hitch pin and link spring, then disengage the connectiong rod from the primary link.
 Turn connecting rod clockwise (1 or more) full turns.
 Re-engage connecting rod in primary link of handle, insert hitch pin and re-test.
 Repeat  -  as necessary.
 Re-install link spring
1
2
Connecting
Rod
Hitch Pin
Primary Link
Drive Bar
BULLETIN 1494V VARIABLE DEPTH DISCONNECT SWITCH
INSTALLATION INSTRUCTION SHEET
5 1020139
42052-116
OF
N/A
N/A
N/A
REVISION
AUTHORIZATION
DR.
CHKD.
APPD.
DATE
DATE
DATE
E - DOC
LOCATION: MILWAUKEE, WISCONSIN U.S.A.
DWG.
SIZE
SHEET
B
1 2 3 4 5 6 7 8
A
B
C
D
E
F
G
H
REFERENCE
DIMENSIONS APPLY BEFORE
SURFACE TREATMENT
(DIMENSIONS IN INCHES)
TOLERANCES UNLESS
OTHERWISE SPECIFIED
.XX:
.XXX:
ANGLES:
42052
- - - - - - - - - - - - - -
- - - - - - -
- - - - - - -
- - - - - - -
- - - - - - -
THIS DRAWING IS THE PROPERTY OF
ROCKWELL AUTOMATION, INC.
OR ITS SUBSIDIARIES AND MAY NOT BE COPIED,
USED OR DISCLOSED FOR ANY PURPOSE
EXCEPT AS AUTHORIZED IN WRITING BY
ROCKWELL AUTOMATION, INC.
4 17
6 1021282
7 1032142