Rockwell Automation 1203 Serial Communications Module Series A - Manual (Page 3)

Summary of Changes
Summary Information These changes have been made since any preliminary photocopy
documents were issued:
Chapter 1 A trademark symbol has been added to 1336 PLUS on page 1-1.
Chapter 2
•
The word “board” has been changed to “module” in the last sentence of
paragraph four on page 2-1.
•
The word “Default” has been added to the description of SW3.7, SW3.8
in, and DH-485 has been removed from, Figure 2.1 on page 2-2.
•
The SLC 5/03 illustration in Figure 2.3 on page 2-4 has been reduced 50
percent.
Chapter 3
•
The note on page 3-9 has been replaced with a new note.
•
The Figure 3.2 heading on page 3-11 has been changed to include 1336
PLUS.
•
The 9-pin D-shell in Figure 3.6 on page 3-14 has been changed to match
the same in Figure 3.5.
•
The range (7.5 – 500HP) has been removed from the first heading on
page 3-17.
Chapter 5
•
Three new tables have replaced Table 5.B on page 5-3.
•
The first paragraph on page 5-4 has been changed to accommodate the
three new tables preceding this text.
•
A sentence has been added to the end of Item 3, Parameter Read Full, on
page 5-4.
•
The Item 8 heading, System File, on page 5–5, has been changed to
System Area.
Chapter 6
•
The Figure 5.1 heading on page 6-1 has been changed to Figure 6-1, and
the figure reference in the first paragraph has changed likewise.
•
The Table 5.C heading on page 6-2 has changed to Table 6.A.
Notes A Notes section has been added to the end of this document.