Rockwell Automation 1204 Reflected Wave Reduction Device - Manual (Page 5)

1204 Reflected Wave Reduction Device with Common Mode Choke 5
Installation The following steps will guide you through mounting the Reflected Wave
Reduction Device.
Mounting
1. Assure that all power has been removed from the drive.
2. Attach the mounting brackets to the back of the chassis using the eight
screws provided. The brackets can be positioned either flush or extended
as shown below.
!
ATTENTION: To avoid a shock hazard, ensure that all power
to the drive has been removed before proceeding. In addition,
wait 3 minutes for the DC bus to discharge.
!
ATTENTION: Enclosure surfaces may be hot and can cause
sever burns. Install in a location that minimizes accidental
contact.
Brackets Extended Brackets Flush
3.6 N-m
32 lb.-in.