Display modes and error messages, Editing device data – Rockwell Automation 937CU-AITXF-DC1 Transmitter Supply Converter Installation Instructions User Manual
Page 10

8
Bul. 937C Transmitter Supply Converter Installation Instructions
Display modes and error messages
Editing Device Data
WARNING: A change in device data will change the operation of the device!
WARNING: Before entering new data into the device, you should therefore as
certain that no danger to the installation will result.
If the Alarm freeze is triggered but the device continues operating normally, a corresponding
message appears in the second line of the display.
If a fault occurs, one of the following messages is displayed until the fault is rectified (when
parameterized):
• Err Mem for device fault,
• Err LB for lead breakage,
In normal operation, the current measured value is indicated in the selected unit.
The display of the device is updated at regular intervals. This can causes a short
flickering of the display. This flickering isn't a defect of the display.
Note
The relays de-energizes when a fault occurs.
FDT Interface
This manual describes Parameterization mode of the universal frequency converter using the
control panel. parameterization mode
for the universal frequency converter is more convenient with a PC using Field Device Tool (FDT)
software.
Some specialized functions can only be selected using the FDT , for instance, pulse suppression
as an alternative to the start-up override.
The FDT interface is the specification describing the standardized data exchange between devices and
control system or engineering or asset management tools. Examples include: PACTware
TM
, FieldCare,
FactoryTalk AssetCentre, and Process Device Configuration. FDT frame software can be downloaded
from the web: www.pactware.com www.fdtgroup.org.
PACTware
TM
is trademark of PACTware Consortium
• Err SC for short circuit,