Rockwell Automation 1398 N-Series Brushless Servo Motor Manual - Manual (Page 9)

Options: Connectors and Shaft Seals
An environmentally sealed package may be formed when an N-Series motor is coupled with sealed
cable assemblies and shaft seals.
Factory manufactured power cables and encoder cables are available in standard cable lengths of 10,
25, 50, 75 and 100 feet (3, 7.6, 15, 23 and 30 meters). Factory cables provide environmental sealing
and shield termination.
Shaft Seal Kits
Connectors and Connector Kits
MOTOR SEAL KITS
MOTOR
SERIES
PART NUMBER
SIZE
(Outside Dia x Inside Dia x Width) mm/in
N-2300 0041-5068 0.035 x 0.001 x 0.005 / 0.875 x 0.250 x 0.125
N-3400 0041-5069 0.044 x 0.019 x 0.010 / 1.125 x 0.500 x 0.250
N-4200 0041-5070 0.044 x 0.025 x 0.010 / 1.125 x 0.625 x 0.250
N-5600 0041-5071 0.054 x 0.030 x 0.010 / 1.375 x 0.750 x 0.250
NOTE: Shaft seals are manufactured to inch dimensions. Millimeter dimensions are conversions from inches.
Shaft seals require a lubricant to reduce wear. Lubricant is provided with kit.
MOTOR POWER CONNECTORS
PART
NUMBER
CONNECTOR
TYPE
9101-1557 POWER - SOLDER
9101-1558 ENCODER - SOLDER
9101-1698 BRAKE - SOLDER
These connectors provide environmental sealing and shield termination.
OTHER MATING CONNECTORS
STRAIGHT CONNECTOR TYPE RIGHT ANGLE
MS3126F14-19S ENCODER - CRIMP KPSE08F14-19S PT08SE14-19S
MS3116F14-19S ENCODER - SOLDER KPT08F14-19S PT08E14-19S
MS3126F14-5S POWER - CRIMP KPSE08F14-5S PT08SE14-5S
MS3116F14-5S POWER - SOLDER KPT08F14-5S PT08E14-5S
MS3126F12-3S BRAKE - CRIMP KPSE08F12-3S PT08SE12-3S
MS3116F12-3S BRAKE - SOLDER KPTO8F12-3S PT08E12-3S
NOTES:
· These connectors provide environmental sealing, but do not provide cable shield termination.
· Angle Connectors are ITT Cannon (KP) and Amphenol (PT).
· Power contacts are size 16 AWG. Crimp type connectors accept wire sizes 20 AWG to 16 AWG.
· Brake and Encoder contacts are size 20 AWG. Crimp type connectors accept wire sizes 24 AWG to 20 AWG.
05 04