Rockwell Automation 14885P KwikLink Lite, Field Network Pressure-Welded Connectors User Manual
Page 3
3
S
After crimping, check to be sure that the cable was
crimped correctly.
Check to be sure that the housing lock is fully hooked
onto the cover tabs.
After crimping, check to be sure that there are no gaps
between the cover and the main unit.
Basic Specifications
Rated current
Power supply (red, black, V+, V--): 4 A
Rated voltage
30V DC
Dielectric strength
1000V AC for 1 minute
Suitability for Use
The products contained in this installation sheet are not
safety rated. They are not designed or rated for ensuring
safety of persons and should not be relied upon as a
safety component or protective device for such
purposes. Please refer to separate catalogs for
safety-related products.
Rockwell Automation shall not be responsible for conformity
with any standards, codes, or regulations that apply to the
combination of the products in the customer’s application or
use of the product.
Take all necessary steps to determine the suitability of the
product for the systems, machines, and equipment with which
it will be used. Know and observe all prohibitions of use
applicable to this product.
Never use the products for an application involving
serious risk to life or property without ensuring that the
system as a whole has been designed to address the
risks and that the Rockwell Automation product is
properly rated and installed for the intended use within
the overall equipment or system.
10000029238 Ver 00
Printed in USA