Rockwell Automation 1608S I-Sense Installation Instructions User Manual
Bulletin 1608s i-sense, Voltage sag detector
Table of contents
Document Outline
- Important User Information
- Additional Resources
- Installation
- Pre-installation
- Environmental Conditions
- Mounting
- Electrical Connections
- 1. Select your voltage configuration from Table 2and follow the instructions in the corresponding wiring diagram from Table 1.
- 2. Use the appropriate wiring diagram and jumper wire positions. The i-Sense is shipped with jumper wires in the LL configuration. The LL and LN diagrams are also shown inside the i-Sense cover. Move or remove jumper wires as needed.
- Nominal Voltage Configurations
- Communications Connections
- Final Check
- External Power Supply
- Initial Battery Charge Time
- Technical Specifications
- Standards Compliance and Certifications
- Compliance Information
- FCC PART 68
- Industry Canada Notice
- FCC Part 15 Class A Digital Equipment
- CTR21 Statement