Rockwell Automation 1608S I-Sense Installation Instructions - Manual (Page 8)

8 Rockwell Automation Publication 1608S-IN001A-EN-P - July 2013
Bulletin 1608S i-Sense® Installation Instructions
Standards Compliance and
Certifications
Compliance Information • cTUVus (OSHA NRTL) listed
• Tested to UL and CSA safety standards
• CE mark (Safety and EMC)
• RoHS compliant
• FCC part 68 (Telephone Equipment)
• FCC part 15 (Emissions)
• Industry Canada CS-03 (Telephone Equipment)
• European Union CTR21 (Telephone Equipment)
FCC PART 68 • This equipment complies with Part 68 of the FCC rules and the
requirements adapted by the ACTA. The finished product containing this
equipment must display a product identifier in the format [US:
3A4MM00BTM]. If requested, this information must be provided to the
telephone company.
• This equipment uses the USOC jacks: RJ11C
• A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules
and requirements adopted by the ACTA. This equipment is designed for
connection to a compatible modular jack that is also compliant. See
installation instructions for details.
• The REN is used to determine the number of devices that may be
connected to the telephone line. Excessive REN on the telephone line may
result in the devices not ringing in response to an incoming call. In most,
but not all areas, the sum of the REN should not exceed five (5.0). To be
certain of the number of devices that may be connected to a line, as
determined by the total REN, contact the local telephone company. The
REN for this product is part of the product identifier that has the format:
[US: 3A4MM00BTM] The digits shown after MM are the REN without
decimal point. (e.g., 00 is a REN of 0.0)
• If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of
service may be required. If advance notice isn’t practical, the telephone
company will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is
necessary. If the equipment is causing harm to the telephone network, the
telephone company may request that you disconnect the equipment until
the problem is resolved. The telephone company may make changes in its
facilities, equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the telephone company will
provide advance notice in order for you to make the necessary
modifications to maintain uninterrupted service.