Rockwell Automation 1336 PLUS - Manual (Page 3)

3. Check the hole pattern on the panel to which the drive will be
mounted. Refer to Figure 3 for the correct pattern.
4. Place the adhesive side of the gasket on the back of the drive.
Line up the holes between the gasket and drive. In this
configuration, the heat sink will be located outside of the
enclosure.
5. Lift drive into place. The screws on the right of the heat sink
should fit through the notches cut into the panel. M5 x 12 mm
screws are required in 18 locations; the tightening torque is 2.9
N-m (26 lb.-in.).
Figure 1
Drive Lifting Locations
Spreader Bar
Wire Rope
Hoist Hook MUST be placed
over Drive Center of Gravity
"S" Hook (Hole A-A)
Open Chassis Drive
(typical vertical mounting shown)
NEMA Type 1 Drive
Hole C-C
Hole B-B
Lifting Eyebolts
Shackle
Shackle
241 mm
(9.5 in.)
cg
Center of Gravity is 50.8 mm (2 in.)
to the left of physical center on
a 380-480V AC, 93 kW (125 HP)
stand-alone drive.
140 mm
(5.5 in.)
381.0 mm
(15.0 in.)