Rockwell Automation 1336 PLUS - Manual

Lifting Instructions for 1336 PLUS and
FORCE

“D” Frame Drives
This publication will guide you through the steps needed to properly
lift and mount the following drives:
•
1336 PLUS – 30-112 kW (40-150 HP)
•
1336 FORCE – 30-112 kW (40-150 HP)
!
ATTENTION: To guard against possible personal
injury or equipment damage . . .
• Do Not allow any part of the drive or lifting mecha-
nism to make contact with electrically charged con-
ductors or components.
• At no time should a person or their limbs be directly
underneath the items being lifted.
• Do not subject the load to high rates of acceleration
or deceleration.
• Inspect all lifting hardware for proper attachment
before lifting drive unit.
The following items will be required to properly lift the drive –
mounting method chosen will determine quantities needed.
Item Load Rating Quantity McMaster-Carr P/N
Wire Rope Sling 462.7 kg (1020 lb.) 2 or 4 3550T113
Adjustable Spreader Bar 1134 kg (2500 lb.) 1 3977T11
Anchor Shackle 1361 kg (3000 lb.) 4 or 6 3663T51
“S” Hook 227 kg (500 lb.) 2 or 4 3631T71
Perform the following steps to vertically mount the drive.
1. Determine the center of gravity for the drive. The hoist hook must
be located directly above the center of gravity to assure that the
drive hangs properly. For example, the center of gravity for a
380-480V, 93 kW (125 HP), 1336 PLUS stand-alone open chassis
drive is about 50.8 mm (2 in.) to the left of center.
Installation Instructions
Required Lifting Components
Vertical Drive Mounting