Rockwell Automation 1606-XLP60BQT Power Supply Reference Manual - Manual

Reference Manual
e g a P e g a P
1. Intended Use .......................................................3
2. Installation Requirements ...................................3
3. AC-Input ...............................................................4
4. Input Inrush Current ...........................................5
5. Output .................................................................6
6. Hold-up Time .......................................................7
7. DC-Input ...............................................................7
8. Efficiency and Power Losses ................................8
9. Functional Diagram .............................................9
10. Front Side and User Elements .............................9
11. Terminals and Wiring ........................................10
12. Lifetime Expectancy and MTBF .........................10
13. EMC ....................................................................11
14. Environment ......................................................12
15. Protection Features ...........................................13
16. Safety Features ..................................................13
17. Dielectric Strength ............................................14
18. Certifications .....................................................15
19. Physical Dimensions and Weight......................16
20. Application Notes ............................................. 18
20.1. Peak Current Capability ...........................18
20.2. Back-feeding Loads ..................................18
20.3. Charging of Batteries ...............................19
20.4. External Input Protection .........................19
20.5. Parallel Use to Increase Output Power ....19
20.6. Daisy Chaining of Outputs .......................20
20.7. Inductive and Capacitive Loads ................20
20.8. Series Operation .......................................21
20.9. Operation on Two Phases ........................21
20.10. Use Without PE on the Input ...................21
20.11. Use at Low Temperatures (-25°C / -40°C) .22
20.12. Use in a Tightly Sealed Enclosure ............22
20.13. Mounting Orientations ............................23
Bulletin 1606 Switched Mode Power Supplies
Catalog Number: 1606-XLP60BQT
Index
• PE and symbol—PE is the abbreviation for Protective Earth and has the same meaning as the symbol .
• Earth, Ground—This document uses the term “earth” which is the same as the U.S. term “ground”.
• T.b.d.—To be defined, value or description will follow later.
• AC 230V—A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%)
included. E.g.: DC 12V describes a 12V battery whether it is full (13.7V) or flat (10V)
• 230Vac—A figure with the unit (Vac) at the end is a momentary figure without any additional tolerance included.
• 50Hz vs. 60Hz—As long as not otherwise stated, AC 230V parameters are valid at 50Hz mains frequency.
• may—A key word indicating flexibility of choice with no implied preference.
• shall—A key word indicating a mandatory requirement.
• should—A key word indicating flexibility of choice with a strongly preferred implementation.
Terminology and Abbreviations