Rockwell Automation 1204 Reflected Wave Reduc Device RWR2 - Manual (Page 6)

6 1204 Reflected Wave Reduction Device
1. Assure that all power has been removed from the drive.
Mounting
2. Determine the best mounting location for your device style. The
device must be mounted on a vertical metal surface and oriented so
the wiring knockouts are on the bottom – The device must be
mounted within 3.0 meters (10 feet) of the drive. The 160 AC Drive
may not be mounted on top of the RWR2 in the “Stack”
configuration.
The mounting brackets on “Book” style devices can be placed on
either side of the chassis, allowing different mounting
configurations (see drawing below).
Important: To assure proper heat dissipation, minimum clearances
must be maintained as shown below.
Drive
RWR2
76.2 mm
(3.0 in.)
Dimensions indicate minimum clearances.
38.1 mm
(1.5 in.)
RWR2
"Book" Style – B Frame Only "Stack" Style
76.2 mm
(3.0 in.)
76.2 mm
(3.0 in.)
76.2 mm
(3.0 in.)
76.2 mm
(3.0 in.)
76.2 mm
(3.0 in.)
Note 1
Note 1
Note 1: Minimum Distance is Limited by
Drive Mounting Requirements
1305
Optional
Mounting Configuration
for "Book" Style Only
Mounting Brackets
("Book" Style Only)
Drive Cables
Motor Cables