Rockwell Automation 937CS-AITMP-DC1 Universal Temperature Converter Installation Instructions - Manual (Page 12)

11
Communication driver
In a PACT ware TM project, communication with a
937CS-AITMP-DC1 is only possible via the
communication driver
P2P USB FDT. If your project does not yet contain such a driver,
please add it to the project from
the device catalogue (see "PACTwa re TM process automation
configuration tool" manual).
The parameters of the communication DTM is the used PC interface and the number of retries.
The parameter is set as follows:
• Double-click the P2P RS232 FDT
driver with the mouse
• Select the Communication Port
• Communication Retries: number
of retries the COM DTM attempts
to establish communication to the
connected device.
To add a 937CS-AITMP-DC1 to a
project, select a
P2P RS232 FDT
driver of the project.
Then add the
937CS-AITMP-DC1
from the device catalog.
Further information on the individual
steps can be found in the
"PACT
ware TM process automation
configuration tool" manual.
The description in the following chapter assumes that a
937CS-AITMP-DC1 has been selected
in the project.
Bul. 937
C Universal Temperature Converter Installation Instructions