Rockwell Automation 1609-S350ES Uninterruptible Power Supply - 350VA - Manual (Page 5)

41063-285-01 (1)
990-2955 05/2006
Operation
Display Panel Indicators and Buttons
* See Troubleshooting.
Indicator Title Description
On-Line The UPS is supplying utility power to the connected equipment.*
AVR Trim The UPS is compensating for a high utility voltage.*
AVR Boost The UPS is compensating for a low utility voltage.*
On Battery The UPS is supplying battery power to the connected equipment.
Overload The connected equipment is drawing more than the UPS power rating allows.*
Replace Battery/Battery
Disconnected
The battery is disconnected or must be replaced.*
Feature Function Description
Power On Press this button to turn on the UPS. Read on for additional capabilities.
Power Off Press this button to turn off the UPS.
Self-Test Automatic: The UPS performs a self-test automatically when turned on, and every two weeks
thereafter (by default). During the self-test, the UPS briefly operates the connected equipment
on battery.
Manual: Press and hold the button for a few seconds to initiate the self-test.
Cold Start When there is no utility power and the UPS is off, the cold start feature will switch the UPS
and connected equipment onto battery power (see Troubleshooting).
Diagnostic Utility Voltage The UPS has a diagnostic feature that indicates the utility voltage.
The UPS starts a self-test as part of this procedure. The self-test does not affect the voltage
display.
Press and hold the button to view the utility voltage bar graph indicator.
After a few seconds, this five-LED Battery Charge indicator on the right of the display
panel will show the utility input voltage.
Refer to the figure on the left for the voltage reading (values are not listed on the UPS).
The indicator on the UPS shows the voltage is between the displayed value on the list and the
next higher value (see Troubleshooting).
Battery
Charge