Rockwell Automation 931U-C9A2C-OP Active Converter, Universal User Manual

Page 10

Changing the instrument setup
1. Open the Setup/Calibration software.
2. Enter your initials using the ‘Enter Initials’ command from the

‘Device’ menu (shortcut is F7).

3. Press the ‘Get from instrument’ button at the bottom of the

screen (shortcut is F9).

4. The screen will now show the instruments current configuration.
5. Save the current configuration to disk using the ‘Save as’

command from the ‘File’ menu.

6. Setup the instrument to suit your application via the

input screen (press F5) and output screen (press F6).

7. Return to the main screen, check the details are correct and

press the ‘Send to Instrument’ button (shortcut F8).

Note: You are required to enter a password to change the
instruments setup. The default password is 100. Make a note of
the instrument password if you change it - otherwise you will have
to send the instrument back to us.
8. Save the changes to disk as a record of changes you have

made.