Rockwell Automation 283A ArmorStart with ArmorPoint Backplane - Getting Started - Manual (Page 28)

28
Publication 283A-QS001C-EN-P - July 2006
Table 10 Sensor Media
➊
➊ See Publication M116-CA001A-EN-P for complete cable selection information.
➋ Replace symbol with desired length in meters (Example: 889D-F4ACDM-1 for a 1 m cable). Standard cable lengths: 1 m, 2 m, 5 m, and 10 m.
NOTE: Stainless steel versions may be ordered by adding an “S” to the cat. no. (Example: 889DS-F4ACDM-1)
Table 11 Sealing Caps
➌
➌ To achieve IP67 rating, sealing caps must be installed on all unused I/O connections.
Table 12 ArmorPoint Media
Description
ArmorStart I/O
Connection
Pin Count Connector Cat. No.
0
0
Input 5-Pin
Straight Female
Straight Male
889D-F4ACDM-
➋
Straight Female
Right Angle Male
889D-F4AACDE-
➋
0
0
Input 5-pin
Straight Female 879D-F4ACDM-
➋
Right Angle Male 879D-R4ACM-
➋
0
0
Input 5-pin
Straight Female
Right Angle Male
879D-F4ACTE-
➋
Output 3-pin
Straight Female
Straight Male
889R-F3AERM-
➋
Straight Female
Right Angle Male
899R-F3AERE-
➋
DC Micro Patchcord
DC Micro V-Cable
DC Micro Y-Cable
AC Micro Patchcord
Description Used on I/O Connection Catalog Number
Plastic Sealing Cap (M12) Input 1485A-M12
Aluminum Sealing Cap Output 889A-RMCAP
Description Length m (ft) Cat. No.
0 ArmorPoint Bus Extension Cable including
Terminating Resistor
1 (3.3) 280A-EXT1
Extension Cable to connect two ArmorStart
Distributed Motor Controllers to ArmorPoint
communication protocol
1 (3.3) 280A-EXTCABLE