Rockwell Automation 20-750-xxxx Network Communication Option Card (for use with PowerFlex 750-Series Drives) - Manual

Installation Instructions
Network Communication Option Module
(for use with PowerFlex
®
750-Series Drives)
Important: For the PowerFlex 20-750-PBUS Profibus option module, disregard
these instructions. Instead, see its User Manual, publication
750COM-UM004, for special installation instructions.
!
ATTENTION: Risk of injury or death exists. The PowerFlex
750-Series drive may contain high voltages that can cause injury or
death. Remove power from the drive, and then verify power has been
discharged before removing the drive cover.
!
ATTENTION: Risk of equipment damage exists. The network
communication option module contains electrostatic discharge (ESD)
sensitive parts that can be damaged if you do not follow ESD control
procedures. Static control precautions are required when handling the
card. If you are unfamiliar with static control procedures, see Guarding
Against Electrostatic Damage, publication 8000-4.5.2.
➊
Remove power from the drive.
➋ Remove the drive cover and lift up the drive HIM cradle (with or without
the HIM installed) to its open position to access the drive control pod.