Rockwell Automation 440R MSR245 Minotaur Safety System Display - Manual (Page 4)

MSR245 Manual 4
MSR245-manual-doc page 4 of 6
In addition to those described up to this point, the following additional diagnostic menu
options will also be displayed when such conditions occur:
Condition Displayed text
Received data missing Receiving no data
Fault in an output module EDM circuit fault
Modules configuration changed
during system operation Y40 circuit fault
MSR200 system internal fault Internal fault
Every fault occurrence indicated by the MSR245 must be acknowledged by pressing “
←”
(key-switch 1).
Fault Indication Text Programming
For the indication of fault conditions, text of up to 3 lines x 20 characters for each input
can programmed by the user. Any characters can be used for such text. This text is
stored in an internal EEPROM, which can be re-written up to 1 million times, and can
retain stored data for at least 40 years. A software package makes it easy to enter and
edit the fault indication text on a PC, and upload it to the Module.
Fault Indication Text Programming Software
The fault indication text of the MSR245 is programmed using a PC connected to it via the
RS-232 serial interface. The MSR240 has to be disconnected for this procedure.
PC system requirements:
• Windows 95 / 98 / ME or Windows NT / 2000 / XP
• An uncommitted RS-232 serial port
The PC has to be connected to the MSR245 via a standard serial connection cable (not
supplied with the unit)